Party & Events
"CONNECTING YOUR KEG 1. Connect the coupler inside the fridge to the keg by aligning the tabs on the coupler with the tabs on the keg and turn clockwise all the way. Pull the black handle out and down, this is called tapping the keg by engaging the coupler. Pull the handle out and lift up to disengage. 2. Turn the CO2 release knob on top of the tank all the way counter clockwise. If needed you should adjust the pressure gauge on the tank. Th...
e gauge should read between 8-12lbs. 3. Turn the red or blue switch below the gauge to open the line. 4. Put the keg in to keep it cool. POURING THE FIRST GLASS Drain the lines of sanitizer by pulling down on the tap. Release the tap to stop pouring. Dump the first glass as it contains a food grade sanitizer. If the flow is too fast or too slow you can adjust the CO2 pressure by turning the control under the gauge. When you are finished with the kegerator and during transportation turn the CO2 off by turning the knob on top of the tank clockwise. One 2.5 lb CO2 is enough CO2 for 2-3 kegs of beer. A 5 lb CO2 should be enough for 3-5 kegs of beer. What causes beer to foam? 1. Temperature:if you bought beer from us the temperature is between 3-5 degrees Celsius. Warmer beer will be foamy so try to keep the temperature consistent. If the beer does get warm allow it to cool before continuing to pour. 2. FRICTION:the movement of the beer in the keg will cause foam; the beer should sit for acouple hours prior to dispensing. 3. PRESSURE:the ideal dispensing pressure should be between 8-12 lbs. 4. When dispensing, tap handle should all open or all closed."
How does the request process work?
What is the cancellation policy?
Am I insured as a renter?
How does Verification work?
Russ in Toronto
This owner is away so may not respond
People also viewed
DJ Equipment Rental
DJ Equipment Hire
Film & Photography Equipment Hire
© Fat Llama Limited 2022